Graco Inc. CED1 Manuel D’Utilisation

1.

Mix material in separate bucket. Gradually add 
water and mix until desired consistency is achieved.

2.

Add mixed material to hopper. 

3.

Place deflect er into hopper to recirculated material. 
NOTE: Keep deflector shield wet once it is in use.

4.

Turn sprayer power ON and flip prime valve fully 
clockwise to prime pump. Place material hose and 
drain line in hopper.

5.

After unit is primed, place prime valve in APPLY 
FINISH position.

6.

Turn flow knob clockwise to increase material flow.

7.

Place head of tool over waster bucket and trigger 
valve until material flows from tool head. Once all 
water has been flushed from hose and tool, position 
tool head over hopper until flow rate is determined.

8.

Apply a couple of test coats to determine proper 
flow speed on sprayer. Fine adjustments can be 
made on valve handle to increase or decrease flow 
speed.

1.

Remove tool-fill flange.

2.

Install box fill adapter.

3.

Place slot of box over box fill nozzle.

4.

Turn Prime Valve to TOOL FILL position.

Do not use with quick-set materials. They can 
harden inside the unit and hose.

ti11670a

ti14876a