SMC Networks D3GNV3 Manuel D’Utilisation
錯誤
錯誤
錯誤
錯誤
!
使用
使用
使用
使用
[
常用
常用
常用
常用
]
索引標籤將
索引標籤將
索引標籤將
索引標籤將
Heading 1
套用到您想要在此處顯示的文字
套用到您想要在此處顯示的文字
套用到您想要在此處顯示的文字
套用到您想要在此處顯示的文字。
。
。
。
188
SMCD3GNV Wireless Cable Modem Gateway User Manual
4. When you have everything working, reconnect your devices to the Internet.
5. Restart all your computers.
Specific Troubleshooting Procedures
The following sections cover specific troubleshooting suggestions you may find helpful if the
basic and advanced troubleshooting procedures in the previous sections did not resolve
basic and advanced troubleshooting procedures in the previous sections did not resolve
your problem.
Unable to Log In to Gateway
If you are unable to log in to the Gateway’s Web management interface:
1. Confirm that the Ethernet cable connecting the computer and Gateway is connected
securely at both ends. Often, just reseating the cable into a connector is all that is required.
2. If you have more than one network port available on the Gateway, plug the cable into a
different port. If the network connection works, the original port on the Gateway is faulty.
However, you can continue to use the other ports.
However, you can continue to use the other ports.
3. The NIC in your co mputer might have failed. If possible, connect a different computer to
the same network cable. If the connection works, the problem is with the NIC. Contact the
NIC manufacturer for support or install a new NIC. If the new computer also fails to connect,
replace the Ethernet cable with a new cable, as you might have a faulty cable. If the
problem persists, contact technical support for the Gateway.
NIC manufacturer for support or install a new NIC. If the new computer also fails to connect,
replace the Ethernet cable with a new cable, as you might have a faulty cable. If the
problem persists, contact technical support for the Gateway.
4. Be sure you are using the correct login information. The factory default login na me is
cusadmin and the password is highspeed. Be sure Caps Lock is off when entering this
information.
information.
5. Run the Ho me Network Wizard (see “Configuring Your Home Network” on page 60).
6. Change the login password (see “Changing the Login Password” on page 99).
Local Networked Devices Unable to Access the Gateway
If devices on the local network cannot access the Gateway:
1. Go to Connection > Status (see “Viewing the Gateway’s Connection Status” on page 44).
2. Under Local IP Network, check that the following statuses are shown:
– Local Network = Connected
– No of Clients connected = a number greater than zero
If your statuses show no local network connection and/or no clients connected, proceed to
the next step.
the next step.