Innovative Control Systems Inc IGWT-660098 Manuel D’Utilisation

The PBO is designed to be surface mounted 
using the back box provided. 

To mount the PBO use the following 
instructions: 

1.  Using a screwdriver, separate the PBO 

from the back box. 

2.  Push out the back knock-out. 

3.  Using the back box as a template, mark 

the mounting holes. 

4. Drill the necessary holes in the 

mounting surface. 

5.  Secure the back box to the mounting 

surface with appropriate hardware. 

6.  Make any and all wire connections that 

require the PBO to be unmounted. 

7.  Replace the PBO to the back box. 

 

You will need 22 AWG, 4 –conductor Plenum-
rated cable for installation. 

 The following instructions assume that 

the Keypad and LC unit are already wired. See 
Chapter 6 for these instructions. 

To wire the PBO to the Keypad, refer to Figure 
7.2 and use the following instructions: 

1.  Remove the Keypad from the white 

back box. 

2.  Remove the LC Unit cover. 

3.  Using the RED wire, connect (with a 

spade crimp connector) the left prong of 
the PBO plug to pin 5 of the Keypad. 

4.  Using the GREEN wire, connect (with a 

butt splice) the negative (-) of the Green 
LED of the PBO to pin 11 of the 
Keypad which will also be connected to 
“Reset In” of the LC unit.