Zebex Industries Inc BT-CRADLE Manuel D’Utilisation

 

 
Scanning a series of programming bar code labels can configure the scanner. 
This allows decoding options and interface protocols to be tailored to a specific 
application. The configuration is stored in non-volatile memory and will not be lost 
by removing power from the scanner. 
 
The scanner must be properly powered before programming.    If you are about to 
change the cradle host of parameter, the scanner and cradle must be in pairing 
status to prevent failure in programming operation. 
 
During the programming mode, the scanner will acknowledge a good and valid 
reading with a short beep. It will give long beeps for either an invalid or bad 
reading. 

 
 

 

The factory default setting table gives the default settings of all the programmable 
parameters. The default settings will be restored whenever the "Reset" 
programming label is scanned and the laser scanner is in programming mode. 
 
Factory Default Setting 

 

Radio communication 
Bluetooth Host 

Cradle Host 

Pairing mode 

Unlocked 

Data transmit 

Normal 

Radio protocol timeout 

5 seconds 

Power off timeout 

20 minutes 

Encryption Enable 

 

Baud rate   

9600 

Parity none 
Data Bits 

8 

Stop Bit 

1 

RTS/CTS off 
Terminator <CR><LF> 
Keyboard Wedge Communication 

Terminal Type 

PC/AT 

Keyboard US 

keyboard 

Terminator Enter(Alpha 

numeric) 

Terminator type 

Enter 

Code mode 

Scan code 

 

32