Trimble Inc. 6248192-B1 Manuel D’Utilisation
SPSx80 Smart GPS Antenna User Guide
47
Setting up the Receiver
5
Setting up the rover receiver on a rod
For rod-based operation, mount the SPSx50 Modular
GPS receiver as follows:
GPS receiver as follows:
1.
Mount the two rod brackets on the rod.
2.
Tighten the top bracket, making sure that it is at
a convenient height for the receiver.
a convenient height for the receiver.
3.
Place the receiver in the slot in the rod bracket,
and secure with the tripod clip.
and secure with the tripod clip.
4.
Move the lower rod bracket down until it is over
the second tripod clip on the receiver, and then
tighten the rod bracket onto the rod. The
receiver is held in place between the two
brackets.
the second tripod clip on the receiver, and then
tighten the rod bracket onto the rod. The
receiver is held in place between the two
brackets.
5.
Insert the controller into the controller bracket
as shown opposite.
as shown opposite.
6.
Use the 5/8" thread to attach the GPS antenna to
the top of the rod.
the top of the rod.
7.
Use the GPS antenna cable to connect GPS
antenna to the receiver.
antenna to the receiver.
For rod-based operation, mount the SPSx80 Smart GPS antenna as follows:
1.
Mount the receiver on the top of the rod using the 5/8"
×11 thread in the base of
the SPSx80.
2.
Insert the controller into the controller bracket.
3.
The SPSx80 and controller communicates through Bluetooth wireless
technology. However, if a cable is required, connect the cable between the
controller and receiver (see Figure 5.6 through Figure 5.7).
technology. However, if a cable is required, connect the cable between the
controller and receiver (see Figure 5.6 through Figure 5.7).