Hughes Network Systems HNS9101 Manuel D’Utilisation

 
S

1.  Connect the blue Ethernet cable to your laptop’s 

network interface and insert the other end of the 
connector into the Satellite IP Modem. 

2.  To check the active interface, press and hold the 

SELECT button for a few seconds. If the Ethernet 
light flashes red then Ethernet is already selected. 

If not, press the SELECT button once or twice as 
needed to change the selection to Ethernet. After a 

short pause, the Satellite IP Modem will restart with 
the Ethernet interface selected. If the Satellite IP 

Modem is under battery power it will power down; 
press and hold power button to reapply power. 

 
 
 

1.  To check the active interface, press and hold the 

SELECT button for a few seconds. If the Bluetooth 
light flashes red then Bluetooth is already selected. 

If not, press the SELECT button once or twice as 
needed to change the selection to Bluetooth. After 

a short pause, the Satellite IP Modem will restart 
with the Bluetooth interface selected. If the 
Satellite IP Modem is under battery power it will 

power down; press and hold power button to 
reapply power. 

2.  Place your Bluetooth enabled PC in proximity to 

the Satellite IP Modem so the PC can bond to it. 

Use the factory default Bluetooth passkey “blue” when prompted for it by the 
Bluetooth control application on your PC. 

3.  Enter into the Bluetooth control application the DNS values from the 

configuration instructions given to you by your service provider. This must be 
done even if those values are already entered into the Satellite IP Modem 

previously. You may need to consult with your PC’s Bluetooth Device vendor 
regarding how DNS values can be entered into their Bluetooth Control 

application. 

8 

Regional BGAN Satellite IP Modem User Manual