Hughes Network Systems HNS9350 Manuel D’Utilisation
12
Hughes 9350 BGAN Terminal User Guide
S
ETUP
P
AGE
The Setup page allows the User to configure various parameters of the UT. A description of each
item on the page follows:
item on the page follows:
1. Terminal Local IP Address: This allows the User to change the local IP address of the
terminal from the default 192.168.128.100 IP address. Only the last two octets are
available to change. Once the local IP address is changed on this page and applied,
the IP address ranges for the DHCP server, the PDP Context page and ACA page will also
be changed automatically. Note: Updates to this field will not take affect until the UT is
rebooted.
available to change. Once the local IP address is changed on this page and applied,
the IP address ranges for the DHCP server, the PDP Context page and ACA page will also
be changed automatically. Note: Updates to this field will not take affect until the UT is
rebooted.
2. DHCP Address Range: This allows the User to set the range of DHCP addresses that are
given out by the UT to any connected TE.
3. Idle-mode DHCP Lease Time: Idle-mode DHCP Lease Time refers to the DHCP lease time
when the UT is not connected to the network. This parameter allows the User to change
the default time (60 seconds) that the DHCP lease to the TE is good for. This parameter
was introduced because of a problem with some models of Cisco routers that will not
accept a short DHCP lease time. Note: The longer the Idle-mode DHCP lease time, the
the default time (60 seconds) that the DHCP lease to the TE is good for. This parameter
was introduced because of a problem with some models of Cisco routers that will not
accept a short DHCP lease time. Note: The longer the Idle-mode DHCP lease time, the