Titan Electronics Inc NETCOM423 Manuel D’Utilisation
Page
11
NetCom 123 WLAN, 423 WLAN,
2. I
NTRODUCTION
This manual covers several different models of NetCom Devices, in
particular the Wireless operating devices. In general the operation is the
same on all models, except where explicitly noted otherwise.
The VS NetCom devices are designed to remotely operate serial ports
over networks. The new network interface is WLAN (Wireless LAN
according to 802.11g) with 54Mbit/s transfer rate. The interface of
100Mbit/s Ethernet as on all cable operated models is also available.
The transport is implemented via TCP/IP protocol. Therefore control is
available via WLAN, Ethernet, Intranet and Internet. Starting with
Firmware version 2.2 all communication with the device may happen
encrypted with strong algorithms.
The supplied driver software hides the network transfer from your
applications. Software applications using standard COM ports need no
change to operate via NetCom through the virtual serial ports.
The devices come with a steel case well suited for industrial
environments.
NetCom supports high serial speeds up to 3.6 Mbps. All serial ports
operate in three configurable ways. There is the common RS-232 mode
(up to 921 kbps), and the ports also offer the industrial RS-422 and
RS-485 configuration (up to 3.6 Mbps). In RS-485 mode the NetCom
may use the Automatic Receive Transmit (ART) control logic to follow
the RS-485 specifications for transmitting data. No special code is
necessary to be implemented in your software applications.
particular the Wireless operating devices. In general the operation is the
same on all models, except where explicitly noted otherwise.
The VS NetCom devices are designed to remotely operate serial ports
over networks. The new network interface is WLAN (Wireless LAN
according to 802.11g) with 54Mbit/s transfer rate. The interface of
100Mbit/s Ethernet as on all cable operated models is also available.
The transport is implemented via TCP/IP protocol. Therefore control is
available via WLAN, Ethernet, Intranet and Internet. Starting with
Firmware version 2.2 all communication with the device may happen
encrypted with strong algorithms.
The supplied driver software hides the network transfer from your
applications. Software applications using standard COM ports need no
change to operate via NetCom through the virtual serial ports.
The devices come with a steel case well suited for industrial
environments.
NetCom supports high serial speeds up to 3.6 Mbps. All serial ports
operate in three configurable ways. There is the common RS-232 mode
(up to 921 kbps), and the ports also offer the industrial RS-422 and
RS-485 configuration (up to 3.6 Mbps). In RS-485 mode the NetCom
may use the Automatic Receive Transmit (ART) control logic to follow
the RS-485 specifications for transmitting data. No special code is
necessary to be implemented in your software applications.
2.1. F
EATURES
Single power supply DC 9V-30V, 200-600 mA@12V
AC 100-240V 47-63Hz, 25VA
Wireless LAN 802.11b/g for 54Mbit/s
Ethernet 10/100BaseTx for auto-configuration
Three serial port interfaces: RS-232, RS-422 and RS-485
Max. 3.686.400 bps, half- and full-duplex
TCP/IP configuration fixed or by DHCP
Easy remote configuration via SNMP
Drivers for Windows™ and Linux operating systems
Documented interface for every networked operating system
Ethernet 10/100BaseTx for auto-configuration
Three serial port interfaces: RS-232, RS-422 and RS-485
Max. 3.686.400 bps, half- and full-duplex
TCP/IP configuration fixed or by DHCP
Easy remote configuration via SNMP
Drivers for Windows™ and Linux operating systems
Documented interface for every networked operating system