Titan Electronics Inc NETCOM423 Manuel D’Utilisation

The “Server 

Parameter” allow 

configuration of the NetComs 
name and of course all 
parameters in IP-settings. The 
Server 

Name is used as the 

ESSID of the Wireless Ad-hoc 
mode. Generally it is used as 
information, e.g. in the 
NetCom Manager program or in 
SNMP. You may choose the 
network interface as 

Cable, 

Wireless 

or both (with 

priority). 
Manual changes of IP parameters 
are only available with “DHCP” 
set as 

Disabled

. When DHCP 

is not used, enter “IP Address” 
and “Netmask”, as well as the 
“Broadcast” address. “Gateway” 
is required, if there are Routers 

in the network. DNS is used to access other stations by name. The 
“ConfigPort” is used to access the NetCom for administration via 
Telnet. It is suggested to use the standard value for Telnet, TCP port 
number 23. However it may be changed for different purposes. This 
does not change the function of the Telnet menus. 

 

Image 19: Web Panel Server Parameter 

Firmware version 2.2 introduces the new function as Print Server. The 
TCP Port defined by RFC1194 is 515, under certain circumstances you 
may change the “PrintServerPort”. More about Print Server function at 
the configuration of the serial ports. 
“KeepAlive” is an intrinsic function of the TCP/IP protocol. If used it 
causes network traffic, but problems are detected earlier. In a LAN this 
is usually not a problem. However, if used via DialUp connections this 
may cause problems. If this functions is used, you must define an 
interval in seconds. NetCom has a better chance to react on network 
problems, or failed hosts. Even dropping an old connection may be 
useful in certain environments. 

Page 

27 

NetCom 123 WLAN, 423 WLAN,