Titan Electronics Inc NETCOM423 Manuel D’Utilisation
the option of additional protection by “Password”. When a password is
configured, the NetCom sends the question “Password: “ to the client.
The user (his application) must first send the password, followed by
a <CR> character. The password is not echoed to allow usage with
Telnet on a Monitor.
configured, the NetCom sends the question “Password: “ to the client.
The user (his application) must first send the password, followed by
a <CR> character. The password is not echoed to allow usage with
Telnet on a Monitor.
5.1.2.2.3.
TCP Raw Client
Also as Raw Client the NetCom
requires very few parameters.
Under certain conditions it
establishes a Raw TCP connection
to a pre-defined “Destination”.
Since version 2.0 of the NetCom
Firmware the Destination can hold
requires very few parameters.
Under certain conditions it
establishes a Raw TCP connection
to a pre-defined “Destination”.
Since version 2.0 of the NetCom
Firmware the Destination can hold
multiple hosts as targets for a connection. They are entered as a comma
separated list of DNS names or IP-Addresses. Each destination will
have a TCP port number, separated by a colon. Instead of a single
IP-Address or DNS name, a range of IP-Addresses is also valid. This
range must be followed by the TCP port number, as in 192.168.254.12-
192.168.254.17:2077.
separated list of DNS names or IP-Addresses. Each destination will
have a TCP port number, separated by a colon. Instead of a single
IP-Address or DNS name, a range of IP-Addresses is also valid. This
range must be followed by the TCP port number, as in 192.168.254.12-
192.168.254.17:2077.
Image 32: Web Panel Raw Client
The parameter “Connect” defines if NetCom uses the connections as
Permanent
,
Triggered
or
DSR
. With
Permanent
or
Triggered
any activity on the serial ports establishes the connection, inactivity of
longer than the “ShortHoldTime” cause NetCom to close the
connection.
longer than the “ShortHoldTime” cause NetCom to close the
connection.
DSR
is new since Firmware version 2.0, the
TCP-connections follow the state of the DSR signal at the NetCom
serial port. When it becomes active they are established, until DSR
becomes inactive. At that moment the connections are dropped.
serial port. When it becomes active they are established, until DSR
becomes inactive. At that moment the connections are dropped.
Page
35
NetCom 123 WLAN, 423 WLAN,