Titan Electronics Inc NETCOM423 Manuel D’Utilisation
8.1.4.1.1. Standard
AT-Commands
These commands are based on the old Hayes Modem
8.1.4.1.2. Extended
AT-Commands
AT Hayes-Standard IP
Modem
Function
A
Answer Call
Accept a connection
Bn ITU-T
modulation
Define
some modem operation modes
Dnnn Dial
connection,
basically phone
number as nnn
number as nnn
Connect to the target system by
IP-Address and TCP-Port. E.g.
ATD10,0,8,42,2023 will “dial” to
port 2023 on IP-Address 10.0.8.42
IP-Address and TCP-Port. E.g.
ATD10,0,8,42,2023 will “dial” to
port 2023 on IP-Address 10.0.8.42
E
Echo on/off
Enable/Disable local echo of
command
command
H0
Hang up
Terminate the TCP connection.
I
Device Information
I0 through I9 report information
L
Speaker Volume
Ignored, always answered with OK
M
Speaker On/Off
Ignored, always answered with OK
N
Auto serial speed
N0 no Auto, N1 reports error
O
Return to data mode
Q
Result Codes
Enable or disable result codes/strings
S=nn/S? S-Register
Set/request configuration registers
V0/1
Responses
Numeric/text responses to commands
X
Busy/Dial detect
Ignored, always answered with OK
Z
Reset to User profile Standard
Table 7: IP Modem Standard AT-Commands
AT Standard-Extensions IP
Modem
Function
&C
DCD control
When to turn on DCD (by
IP-Modems DTR)
IP-Modems DTR)
&D
DTR meaning
Hang Up, Command Mode or Reset
&F
Load factory Default
&K Flow
Control
&S
DSR control
When to turn on DSR (by IP-Modems
DTR)
DTR)
&V View
Profiles
&W
Store Profile
&W0/&W1 is “Standard”. ATZ1
loads profile 1
loads profile 1
823RM WLAN, 1623RM WLAN
Page
90