Titan Electronics Inc NETCOM423 Manuel D’Utilisation
823RM WLAN, 1623RM WLAN
Page
94
8.1.5.7.
AT V (verbose) [ATV1]
Responses as numeric values (ATV0) or as text strings (ATV1).
OK 0 CONNECT
1
RING 2 NO
CARRIER
3
ERROR 4 CONNECT
1200 5
NO DIALTONE 6 BUSY
7
NO ANSWER
8
8.1.5.8.
AT H (hangup) [ATH0]
Command to disconnect. Also used as ATH0. The related version
ATH1 to just go off-hook is not supported, and reports an ERROR.
8.1.5.9.
ATH1 to just go off-hook is not supported, and reports an ERROR.
8.1.5.9.
AT I(n) (information) [ATI0]
Report technical information about the IP-Modem. It is frequently used
to identify the device. The answer is always sent as
<cr><lf><#response#><cr><lf> <cr><lf>OK<cr><lf>. Here are the
defined #response#-strings.
ATI or
ATI0
to identify the device. The answer is always sent as
<cr><lf><#response#><cr><lf> <cr><lf>OK<cr><lf>. Here are the
defined #response#-strings.
ATI or
ATI0
230 230.4kbps
maximum
ATI1
100000000 100Mbps
Ethernet
ATI2
ATI3
Version 1.0 / <compile-date>
Version of
Modem-Firmware
Modem-Firmware
ATI4
Current Profile
ATI5
ATI6
NetCom 230k IP-Modem
Device Identification
ATI7
ATI8
ATI9
(<Name>\Serial#\IP-#:port\Com-
X\NetCom)
X\NetCom)
Display serial port
used
used
ATI10
ATI11
<very extended information>
8.1.5.10.
AT S (setup)
Set and read the S-registers for configuration. ATSrr? is a request to
read the current value, ATSrr=nnn stores the value nnn in the register
rr. Unknown registers report ERROR. See Section 8.1.4.2 above for
possible registers and parameters.
read the current value, ATSrr=nnn stores the value nnn in the register
rr. Unknown registers report ERROR. See Section 8.1.4.2 above for
possible registers and parameters.