Itron Inc. OW3 Manuel D’Utilisation

Installing the CGR Mounting Bracket

1

Alignment slots

2

4 Hex head mounting bolts (8mm x 25mm)

supplied with the installation kit

3

Center stud with self-locking hex nut

1. Position the RF Filter mounting bracket over the center stud and slide down behind hex

nut.

2. Insert the four 8mm x 25mm mounting screws supplied with the installation kit into the

threaded holes in the base mounting plate. Do not tighten bolts until all are started.

Note: The four alignment slots in the mounting brackets allow the CGR and the filter unit
to be rotated either clockwise or counterclockwise for alignment purposes. Inserting the
mounting bolts as shown allow the unit to rotate counterclockwise. Inserting all four bolts
in the holes at the other end of the slot allows the unit to be rotated clockwise.

3. Adjust the alignment of the CGR and RF Filter to the desired orientation and tighten the

four mounting bolts and the hex nut on the center stud. Use a torque of 6–7 foot-pounds
when tightening the bolts and nut.

External Antenna Installation

OpenWay® Riva CAM3 Installation Guide

35