CALAMP WIRELESS NETWORKS INC. BDP3-AMP Manuel D’Utilisation
120 20191-100a
Paragon-III User Manual
15
3.1.6.1
Power Supply Rear Connections
The rear panel connections are:
• Auxiliary Inputs –
• Auxiliary Inputs –
The DE-9 connector on the T809-10 rear panel
provides access to the remote control and remote
sense functions of the power supply.
provides access to the remote control and remote
sense functions of the power supply.
• Output Voltage Adjust –
The output voltage of the power supply can be in-
creased (up to 18V approximately) to compensate
for the voltage drop lost along the cable. Access the
trim-pot through a small hole on the rear panel.
creased (up to 18V approximately) to compensate
for the voltage drop lost along the cable. Access the
trim-pot through a small hole on the rear panel.
To adjust the output voltage use a trimmer tool with
a Phillips head or 3mm blade (do not use a stan-
dard flat blade screwdriver to make the adjust-
ment):
a Phillips head or 3mm blade (do not use a stan-
dard flat blade screwdriver to make the adjust-
ment):
• To increase the output voltage, turn the trim-
pot clockwise.
pot clockwise.
• To decrease the output voltage, turn the trim-
pot counterclockwise.
pot counterclockwise.
If the output voltage is increased on a power supply
operating at, or close to, full load, the power supply
loading must be reduced accordingly or the module
may overheat and shut down.
operating at, or close to, full load, the power supply
loading must be reduced accordingly or the module
may overheat and shut down.
• Feedthrough Terminal Block –
The DC Output Terminal block on the rear of the
T809-10 is a Phoenix Contact HDFKV 10. This is a
screw-type terminal connector that uses a cage
mechanism to clamp the conductor(s). See section
2.5.1.1.1 for recommended torque settings.
T809-10 is a Phoenix Contact HDFKV 10. This is a
screw-type terminal connector that uses a cage
mechanism to clamp the conductor(s). See section
2.5.1.1.1 for recommended torque settings.
Figure 13 - T809 Rear panel
• Protective Bonding Terminal –
The Radio Assembly requires a secure ground connection. See section 2.5.1.1 for connection details.
• 120 VAC Connector –
Use the supplied 10A-rated IEC type power cord.
AUXILIARY INPUTS
OUTPUT 13.8 VDC
30A MAX
- +
- +
100-240 VAC 50/60Hz
1
9
Output voltage adjust
Feedthrough terminal
block
13.8 VDC output
Negative (-)
Positive (+)
Protective
bonding
terminal
terminal
Neutral
Live
Earth