CALAMP WIRELESS NETWORKS INC. MCUC5 Manuel D’Utilisation

This document provides the information re-
quired for the installation, operation and main-
tenance of the 

DATARADIO

 Integra-T radio-

modem.

This manual is intended for use by system de-
signers, installers and maintenance technicians

 

The Integra-T is a high speed transparent
radiomodem designed specifically to fit the
needs of SCADA, telemetry and control
applications. The Integra-T provides the com-
munication links among data equipment for
installations where wired communication is
impractical.

 

The Integra-T will work with most makes and
models of RTU, PLC and with their protocols
(usually polling) . Configuration settings allow
tailoring for a variety of applications.

 

The Integra-T supports:

1.  Point to point Master–Slave or Peer to Peer

configurations in simplex or half duplex
modes.

2.  Point to multipoint Master–Slave configur-

ation in simplex or half duplex modes.

3.  Point to point and point to multipoint in-

stallations that require a repeater.

4.  Point to point PC–PC links for testing pur-

poses.

 

Settings and connections for these configura-
tions are given later in this manual.

 

The Integra-T has the following characteristics:

1.  One COM port for connection to DTE.

Speeds 300 - 9600 b/s.

2.  One SETUP port, for configuration and

diagnostics.

3.  Built-in 5 watt transceiver, operating in the

VHF, UHF or 900 MHz communications
bands. Half duplex or simplex operation.

4.  Fully transparent operation with error-free

data delivery.

5.  Allows transmission of “break” characters.
6.  DOX (Data Operating Transmission) or

RTS mode.

7.  Stations may be set as “master” or “remote”

to prevent remote stations from hearing each
other.

8.  Full local and remote diagnostics
9.  Two 8 bit analog inputs (0 - 10V).
10.  Low power consumption modes: “sleep”

and “suspend” modes (nominal 7mA).

 

Operating characteristics of the Integra-T are
configured by means of Integra Radio Service
Software (RSS - p/n 085 03281-000) available
from your sales representative. Also available is
the Integra Radio Diagnostic Software (RDS)
which permits both local and remote diagnostics
and the Remote Radio Service Software (RRSS)
which allow remote programming. The RSS,
RDS and RRSS programs are MSDOS based
and will run on any 486 or higher PC (2 Mega-
bytes memory required).