USA Alinco Branch DR-135T Manuel D’Utilisation
7
3. Initial Installation
For a mobile station set up
Location
The transceiver may be installed in any position in your car, where the controls and microphone are
easily accessible and it does not interfere with the safe operation of the vehicle or the performance
of the set. If your vehicle is equipped with air bags, be certain your radio will not interfere with
their deployment. If you are uncertain about where to mount the unit, contact your vehicle's manu-
facturer.
easily accessible and it does not interfere with the safe operation of the vehicle or the performance
of the set. If your vehicle is equipped with air bags, be certain your radio will not interfere with
their deployment. If you are uncertain about where to mount the unit, contact your vehicle's manu-
facturer.
Installing a Mobile Antenna
Use a 50 ohm coaxial cable to connect the antenna. Mobile antennas require an appropriate mount-
ing base for proper installation and operation. For more information, see the documentation for
your antenna.
ing base for proper installation and operation. For more information, see the documentation for
your antenna.
Installing the Transceiver
See the figure on the below.
Screw-fixed
base
base
Magnet base
Car body
Washer (M5)
Tapping screw
(M5 x 20 mm)
(M5 x 20 mm)
Mounting bracket
＜
For making 4+/-0.2 mm ø hole in glove box bottom
＞
CAUTION:
After installing your antenna, ensure that you have the best possible SWR reading.
High RF environments can cause severe damage to your unit. Ensure that you are not
in a high RF environment when operating the transceiver.