VTech Telecommunications Ltd 80-4227-00 Manuel D’Utilisation

This document is proprietary to V

TECH 

E

NGINEERING 

C

ANADA 

L

TD

.

23624

Specifications are preliminary and are subject to change without notice.

When the handset is off-hook and the RF link is broken between the handset and base, the handset
alerter will emit a beep signaling a “CHANNEL SEARCHING..” condition as the handset begins scanning
for the base.

The  “CHANNEL SEARCHING..” indication will remain on the LCD  as the handset tries to reestablish
communication with the base.  If this is not done within 30 seconds, the unit will display “CALL DROPPED”
for 3 seconds and will then enter standby mode (idle/low power mode).  At intervals of 10 seconds, the
handset will wake up and display “CHANNEL SEARCHING..” again as it scans all 10 channels (channels
0 through 9) before blanking the display and reentering standby mode.

Note: Once entering standby mode while in an out-of-range condition, the handset will emit out-of-range
tones at 10 second intervals until the battery dies or the handset is able to re-establish communication
with the base.  In this condition, the battery life will be greatly diminished.

If the PHONE key is pressed while the unit is in an out-of-range condition and in standby mode, a
KEYCLICK will be generated and after two seconds the out-of-range warning beep is generated and
channel search will be initiated.  The “CHANNEL SEARCHING..” message then appears on the display for
30 seconds.  After 30 seconds the unit will display “CALL DROPPED” for 3 seconds and enter standby
mode.

If the unit is within range of the base, the handset will automatically re-establish the link within 15 seconds.
The unit will then display:

for 3 seconds and then blank the display and enter into standby mode.

CHANNEL

CHANNEL

CHANNEL

CHANNEL
SEARCHING...

SEARCHING...

SEARCHING...

SEARCHING...

FOUND

FOUND

FOUND

FOUND
CHANNEL x

CHANNEL x

CHANNEL x

CHANNEL x