Itron Inc. 100TMS Manuel D’Utilisation
100T-MS Methane Sensor
Endpoint User Manual
The 100T-MS is an endpoint that includes a
methane sensor used to detect, record, and
transmit methane levels and alarms to a 100
Series collector or repeater.
To Install the Endpoint
1.
Attach the endpoint mounting bracket to
the wall or pipe and use the bracket
leveling feature to ensure it is level.
2.
Attach the endpoint to the mounting
bracket using the screws provided.
3.
Cover the screws with the tamper caps.
4.
Using an FC300 radio put the endpoint
into Run mode.
5.
Verify that methane level messages for the
particular endpoint ID are being received
at the head end application.
Troubleshooting
If methane level messages are not being received,
check the following:
•
The Endpoint is in Run mode
•
The CCU or repeater is installed within
range of the endpoint is powered.
•
The head end application is connected to
the correct database that contains the
endpoint data.
Service
The endpoint contains a non-serviceable lifetime
battery. If the unit fails, please return to Itron for
repair/replacement.
Compliance Statement
This device complies with Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
Operation is subject to the following two
conditions:
• This device may not cause harmful interference.
• This device must accept any interference that
may cause undesirable operation.
• This device must accept any interference that
may cause undesirable operation.
This device must be permanently mounted
such that it retains a distance of 20
centimeters (7.9 inches) from all persons in
order to comply with FCC RF exposure levels.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving
antenna.
antenna.
•
Increase the separation between the
equipment and receiver.
equipment and receiver.
•
Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio
or TV technician for help.
or TV technician for help.
Warning
ELECTROMAGNETIC COMPATIBILITY
Use only approved accessories with this
equipment. Unapproved modifications or
operation beyond or in conflict with these
instructions for use may void authorization by
the authorities to operate the equipment.
equipment. Unapproved modifications or
operation beyond or in conflict with these
instructions for use may void authorization by
the authorities to operate the equipment.