DEI Headquarters Inc. AESTH05 Manuel D’Utilisation
Entering the 4-digit access code.
The keypad illuminates (half brightness) when a button is pressed. The maximum delai between
each press is 2-seconds, if a subsequent button is not pressed within 2-seconds, the keypad will
shut off and the sequence must be started over from the beginning.
each press is 2-seconds, if a subsequent button is not pressed within 2-seconds, the keypad will
shut off and the sequence must be started over from the beginning.
The button 9/0 flashes once (full brightness) every time a button is pressed.
When a valid access code is entered, the keypad shuts off momentarily then, button 9/0 flashes once
(0.5 sec.) then the keypad elluminates again for 2-seconds to allow performing the desired function.
(0.5 sec.) then the keypad elluminates again for 2-seconds to allow performing the desired function.
Master Access Code
The keypad is featured with a permanent unique 4-digit Access Code from the factory, this code is
called the Master Access Code. Its serial is based on the unit I.D. number and it is not changeable.
The keypad is featured with a permanent unique 4-digit Access Code from the factory, this code is
called the Master Access Code. Its serial is based on the unit I.D. number and it is not changeable.
User Access code
The user access code is 4-digit I.D. number that is programmed by the user.
The user access code is 4-digit I.D. number that is programmed by the user.
Security
The keypad is provided with security features that prevents an intruder from using the system.
The keypad is provided with security features that prevents an intruder from using the system.
The keypad is diseabled for a 10-seconds period if any of the following occurs;
•
a key is maintened for more than 5-seconds;
•
two or more keys are pressed at the same time (except for the lock command);
•
more than xx tries (9 consecutive keys).
Liste of available functions
After a valid access code is entered, the following functions can be performed.
After a valid access code is entered, the following functions can be performed.
Reprogramming the user access code
Performe the following sequence for changing the user access code.
Performe the following sequence for changing the user access code.
1. Enter the 4-digit Master Access Code;
2. press the 1/2, 5/6 and 9/0 keys simultaneously;
3. after the keypad ends flashing, enter the new 4-digit access code (4 digit max.);
4. press the 1/2, 5/6 and 9/0 keys simultaneously.
2. press the 1/2, 5/6 and 9/0 keys simultaneously;
3. after the keypad ends flashing, enter the new 4-digit access code (4 digit max.);
4. press the 1/2, 5/6 and 9/0 keys simultaneously.
The keypad is ready for using with the new user access code.
Command
Button
Lock*
7/8 & 9/0
Unlock
1/2
Trunk release
3/4
Stop
5/6
Start
7/8
Low Temperature mode
9/0
* Access code is not required to performe this command.