DEI Headquarters Inc. DEI3510 Manuel D’Utilisation
User Guide
P.13
If your vehicle has a manual transmission, Idle Mode can be activated through
the same routine as that used for Ready Mode (page 9); at the last step, press
the
button to lock the doors, arm the system and leave the engine running.
NEW FEATURE
– Push-To-Start Idle Mode
This feature is a variation of “Idle mode”, but made specifically for Push-To-Start
vehicles, with automatic or manual transmissions. (Consult your installer for
availability of this feature.) Follow the same steps as the normal Idle Mode
procedure, except for when re-entering the vehicle while the engine is running;
1. Press unlock
2. Open then close all doors.
3. You have 1.5 minutes (or 3 minutes) to press on the brake pedal, to
get in gear and drive off.
Note 1: Pressing on the brake pedal after the allocated (1.5 or 3-min.) period will
shut the engine down.
Note 2: The engine will continue running until the user re-enters the vehicle or
until the expiration of the run time.
Note 3: If the pre-programmed run-time expires or if the user shuts down the
engine remotely, the vehicle will enter Ready Mode automatically (manual
transmissions only).
Caution!! Do not leave children or pets unattended in a vehicle standing in Idle
Mode.
Valet Mode
When the vehicle is in Valet Mode, the remote starter and alarm functionalities
are disabled. If the vehicle needs to be serviced, or if you park it indoors, Valet
Mode will prevent the engine from being remote-started accidentally.
Any of the following features will put the remote car starter into Valet
Mode:
Ignition Valet: This feature allows you to set Valet Mode using the ignition key.
Remote valet: This feature allows you to set Valet Mode using the transmitter.