DEI Headquarters Inc. DEI3510 Manuel D’Utilisation
User Guide
P.17
Note: The extended run time procedure can only be carried out once per remote
start.
To stop the vehicle, at any moment, simply press and release the
button.
Example: If your remote car starter is programmed for a run time of 3 minutes
and your vehicle has been running for 2 minutes already, pressing the
button
will reset the counter to zero and allow the engine to run for another cycle (in this
case, 3 minutes).
Disable/Enable LED flashing
To disable the LED: Press
and
simultaneously until the remote beeps
once, pauses for 2 seconds, then beeps once again. Release the buttons. The
parking lights will flash 3 times.
To Enable the LED: Press
and
simultaneously until the remote beeps
once, pauses for 2 seconds, then beeps once more. Release the buttons. The
parking lights flash once.
Constant output
Pressing and holding the
button for more than 3 seconds will lock all doors
and will send a constant pulse as long as the
button is held down (maximum
of 15 seconds). This constant pulse can be configured to activate certain
functionalities such as rolling up the windows
– Please refer to your installer to
see if your vehicle is compatible with this option.
Pressing and holding the
button for more than 3 seconds will unlock all doors
and will send a constant pulse as long as the
button is held down (maximum
of 15 seconds). This constant pulse can be configured to activate certain
functionalities such as rolling down the windows
– Please refer to your installer to
see if your vehicle is compatible with this option.