DEI Headquarters Inc. DEI474P Manuel D’Utilisation

A remote that has been programmed to a single-but-
ton configuration will control both arm/lock and dis-
arm/unlock from the same button. Using the one-but-
ton configuration, the transmitter buttons are assigned
to the following functions:

The lock icon button arms/locks and disarms/unlocks
the system. When held for three seconds, Panic
mode is activated

The unlock icon button operates Channel 2 and silent
arms/locks and disarms/unlocks.

When pressed together, the lock and unlock icon
buttons operate channel 3.

A remote that has been programmed to an standard
configuration will use separate buttons for arm and
disarm similar to a factory keyless entry. Using the
expanded configuration, the transmitter buttons are
assigned to the following functions:

The lock icon button arms and locks the system.

The unlock icon button disarms and unlocks the system.

The AUX icon button operates channel 2.

The siren icon button operates Panic only.

When pressed together, the lock and unlock icon
buttons operate channel 3.

Model 474P, 4–Button HF, Stealth Code Remote

Date Code

MADE IN TAIWAN

© 2002 Directed Electronics, Inc. Vista CA 92083

All rights reserved. 9/02

P/N 474P

1.

Key. Turn the key to the ON position 

2.

Door. Open a door (660XP only).

3.

Choose. Within 5 seconds press and release the

Valet/Program button the number of times corre-

sponding to the desired channel listed below.

Once you have selected the channel, press the

Valet/Program button once more and hold it. The

LED will flash the same number of times as the

channel selected and the siren (660XP only) will

chirp to confirm the selected channel. Do NOT

release the button.

4.

Transmit. While holding the Valet/program

button, press the button from the transmitter you

wish to assign to that channel. The unit will chirp

(660XP only) to confirm that the transmitter has

been taught to the receiver 

5.

Release. Once the code is learned you can release

the Valet/Program button and remove the key.

The following Learn Routine can be used to program

this replacement transmitter to the system. In order to

enter the Learn Routine, the system’s Valet/Program

switch must be plugged into the BLUE port.

7

Auto-learn Standard Configuration

8

Auto-learn Single-Button Configuration

9

Delete All Transmitters

This device complies with Part 15 of FCC rules.
Operation is subject to the following conditions: (1) This
device may not cause harmful interference, and (2) This
device must accept any interference received, including
interference that may cause undesired operation.

CAUTION! Changes or modifications not expressly

approved by the party responsible for compli-
ance could void the user's authority to oper-
ate this device.

473_474 Blister Packs.qxd  9/24/2002  3:33 PM  Page 2