DEI Headquarters Inc. DEI6212 Manuel D’Utilisation
11
© 2008 Directed Electronics. All rights reserved.
Note:
In order for the ignition controlled door locks to work, the feature
must be turned on in programming.
Note:
If the ignition is turned on while the vehicle is remote started the
doors do not lock until the remote start shuts off. To avoid being locked
out of the vehicle, do not turn the ignition on until you are ready to drive
the vehicle.
out of the vehicle, do not turn the ignition on until you are ready to drive
the vehicle.
➢
Remote Start
This feature allows you to remotely start and run your vehicle for a
programmable period of time. This makes it possible to warm up the
engine, as well as adjust the interior temperature of the vehicle with
the climate control system. If interior heating or cooling is desired, the
climate controls must be preset, and the fan blower must be set to the
desired level prior to remote starting the vehicle.
programmable period of time. This makes it possible to warm up the
engine, as well as adjust the interior temperature of the vehicle with
the climate control system. If interior heating or cooling is desired, the
climate controls must be preset, and the fan blower must be set to the
desired level prior to remote starting the vehicle.
Important!
(1) Never remotely start the vehicle with the
vehicle in gear, and (2) Never remotely start the vehicle
with the key in the ignition.
with the key in the ignition.
To remote start the vehicle:
Press the single button on the transmitter once.
1.
The remote responds with the remote start On tones and the green
2.
LED on the remote flashes once. The vehicle's parking lights turn
ON constant to confirm remote start operation.
Once the vehicle has started, it runs for the pre-programmed pe-
ON constant to confirm remote start operation.
Once the vehicle has started, it runs for the pre-programmed pe-
3.
riod of time (12, 24, or 60 minutes) or until a shutdown input is
triggered. This can be set to minute increments by your installer.
triggered. This can be set to minute increments by your installer.