DEI Headquarters Inc. DEI7121 Manuel D’Utilisation

Pin Number Setting

Factory Preset Pin Number: 1 (Led Blinks One Time)

In disarming mode, turn ignition ON/OFF 8 times within 15 sec-

ond, and end in ON position on the eighth time. The LED will stay

solid for 2 seconds, then the system enters into PIN setting mode:

1. Confirm the original (preset) PIN Number

Turn the ignition OFF within 10 second, LED will start blink-

ing slowly to confirm the preset PIN Number. Turn the igni-

tion ON once the LED blinks the number of times correspond-

ing to the original preset PIN number. If correct, the siren will

chirp once (if siren does not chirp, it means the preset PIN

number confirmation failed. Start the process over again if

this happens);

2. Input the new PIN NUMBER

Right after the siren chirp once, turn the ignition Off, and the

system enters into new PIN number setting, and LED starts

to flash. When the LED flashes the number of times wanted

for the new PIN number, turn the ignition ON then OFF. The

LED will flash the new PIN number once, and then exit PIN

NUMBER setting mode.

Exit Pin Number Setting

If no operation is performed or the wrong initial password was

entered within 30 seconds, the system will exit PIN NUMBER set-

ting mode.

Valet Mode

You can prevent your security system from automatically arming by

using valet mode, this is very useful when washing the motorcycle,

for example. In valet mode, the security system will not arm, even

with the transmitter, but any accessory functions will continue to

work normally.