DEI Headquarters Inc. DEI7351 Manuel D’Utilisation

29

© 2009 Directed Electronics. All rights reserved.

Trigger Zone Fault Report

When armed by remote command the system runs a status check 
of the alarm trigger zones. Faulty zones (usually caused by dome 
light delay or open trunk) are bypassed and reported via the control 
center LED and remote, while all other trigger zones remain active 
and are monitored to protect the vehicle. Should a faulty zone self 
correct (dome light turns off) it becomes active and is then monitored 
normally. 
The siren chirps once again a few seconds following the arming 
chirps as an audible alert, the control center LED flashes in groups to 
indicate the zone number. The remote will emit a single fault tone and 
play zone specific text that identifies the faulty zones.

Alarm Report when Disarming

The most recent alarm triggers (if any) are reported when the alarm is 
disarmed via the remote control, siren chirps, parking light and control 
center LED flashes. The siren chirps 4 times (or 5 times if NPC on*), 
the parking lights flash 3 times, and the control center LED flashes in 
groups to indicate the last two zones that were triggered (see Table 
of Zones). The 

 text is replaced by 

 and text 

identifying the triggers. The report output will repeat for each disarm
operation until the vehicle is driven.

* See 

 for more details.