DEI Headquarters Inc. DEI7351 Manuel D’Utilisation
32
© 2009 Directed Electronics. All rights reserved.
Valet Mode
Valet mode can be entered and exited by performing the remote valet
command or manually using the vehicle key and the control center
button. When entered, the alarm functions are defeated while the
convenience features still operate normally.
Arm and disarm commands lock and unlock the doors while the
command or manually using the vehicle key and the control center
button. When entered, the alarm functions are defeated while the
convenience features still operate normally.
Arm and disarm commands lock and unlock the doors while the
VALET
text and beeps play to confirm.
Use the following steps to manually enter and exit valet mode:
Turn
1.
the ignition switch on and then off
Immediately
2.
press and release the control center button once
The control center LED turns on when entering and off when exit-
3.
ing.
Power Save
To reduce power consumption the control center LED modifies its out-
put if the vehicle is parked for an extended period. If armed the flash-
ing is reduced after 24 hours. When valet mode is on the control
center LED will turn off after 1 hour and will reset each time the ignition
is turned off.
put if the vehicle is parked for an extended period. If armed the flash-
ing is reduced after 24 hours. When valet mode is on the control
center LED will turn off after 1 hour and will reset each time the ignition
is turned off.
Rapid Resume
If power is ever disconnected by a mechanic or thief, the system will
resume the state it was in at the time of disconnection, when power
is reconnected.
resume the state it was in at the time of disconnection, when power
is reconnected.
Automatic Remote Updates
The system sends a silent message to all remote controls after any
major action has occurred. When the remote receives this message it
updates the status screen icons. This way all users are able to quickly
review the system status just by accessing the status screen.
major action has occurred. When the remote receives this message it
updates the status screen icons. This way all users are able to quickly
review the system status just by accessing the status screen.