DEI Headquarters Inc. DEI7645 Manuel D’Utilisation

1. Press and hold the

AUX

AUX

AUX

AUX

button simultaneously until the

LED comes on solid (after approximately 10 seconds).
Note: The LED flashes once per second while the buttons are
depressed.

2. Release the buttons – the LED turns off.
3. Press/release the corresponding remote control button for the

desired RF range as listed below. The LED flashes in groups to
confirm the range setting.

AUX

AUX

selects the shortest range, the LED flashes once.

AUX

AUX

selects the short intermediate range, the LED flashes twice.

AUX

AUX

selects the long intermediate range, the LED flashes three

times (as the default setting, no initial selection is required).

AUX

AUX

selects the longest range, the LED flashes four times.

4. Once the number is entered, wait for 20 seconds for the re-

mote to exit the routine.
Note: The LED flashes four times confirming the routine is ex-
ited.

Battery Information

The remote controls are powered by 1 coin cell battery (CR-2032)
that can be purchased at most retailers. When the battery begins
to weaken, the operating range will be reduced.

Battery Replacement

1. Unscrew the hardware (if used) on unit rear and remove from

housing.

2. Hold the unit base with one hand and gently twist and pull the

main housing body with the other. This releases all parts of the
housing assembly.

3. Remove battery from clip and replace with a new one while

observing the correct polarity.

4. Reassemble unit and secure with hardware.

Battery Disposal

Directed cares about the environment. If you need to
dispose of the battery, please do so in accordance with
your municipal requirements for battery disposal.

FCC/ID Notice

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions: (1) This device may not cause harmful interfer-

ence, and (2) This device must accept any interference received, including

interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for

Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates and can radiate

radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particu-

lar installation. If this equipment does cause harmful interference to radio

or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one

or more of the following measures.

•

Reorient or relocate the receiving antenna

•

Increase the separation between the equipment and receiver

•

Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected

•

Consult the dealer or an experienced radio/TV technician for help

Any changes or modifications not expressly approved by the party responsi-

ble for compliance could void the user’s authority to operate the equipment.

Canada statements:

This device complies with Industry Canada licence-exempt RSS standard(s).

Operation is subject to the following two conditions: (1) this device may

not cause interference, and (2) this device must accept any interference,

including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables

aux appareils radio exempts de licence. L’exploitation est autorisée aux

deux conditions suivantes : (1) l’appareil ne doit pas produire de brouil-

lage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélec-

trique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement..

G7645A BL 2012-05