Manualsbrain.com
  1. Manuels
  2. Marques
  3. DEI Headquarters Inc.
  4. DEIBLE1
  5. Manuel D’Utilisation

DEI Headquarters Inc. DEIBLE1 Manuel D’Utilisation

Télécharger
Page de 20
12
DS4+ HK2
© 2016-10-20 Directed. All rights reserved.
Module programming
To connect the module:
1
Please ensure that the vehicle is in a safe location and cannot move forward during 
programming. For vehicles equipped with a manual transmission, make sure the gearshift 
lever is in the neutral position.
2
Connect all the harnesses to the DS4+, EXCEPT the 12-pin main power harness.
Connect all but the 
12-pin harness
3
Connect the 12-pin main power harness, and wait until the LED turns ON solid red.
Must be 
connected LAST
&
Solid
4
Turn the key to the ON position. The LED will flash green then solid
green for 3 seconds, and then turns OFF.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
Flashes
Solid x 3secs
Off
&
&
&
5
If the vehicle does not have a transponder, the LED will remain solid red. Press the 
programming button 5 times to skip the transponder programming.
The LED turns ON solid orange for 3 seconds then shuts off when programming is done.
Press x 5
&
Solid
Off
Solid x 3secs
&
6
Turn vehicle ignition OFF once the module is successfully programmed.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
7
Pair remotes (if applicable). For information on how to pair a specific remote, please 
refer to its corresponding owner documentation, which can be found inside the product 
packaging of the complete system or on www.directechs.com.*
Pair 
remotes*
8
By default, the tachometer is preprogrammed for the vehicle. For instructions on how to
program tach, see page 16.
Initialize 
tachometer
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.