DEI Headquarters Inc. HYU1800 Manuel D’Utilisation
Page-24
PROGRAMMING
Programming of the remote starter transmitters
How to enter remote starter programming mode
THE INSTALLER …
ANTENNA LED
•
Ensure that the vehicle hood is OPEN.
•
Press and hold the PAB button for 4 seconds (Fig 11).
•
Release the PAB button (the antenna LED will turn ON).
“ON”
•
While the antenna LED is on, press the PAB button once
more and release immediately.
“ON” for 20 seconds
•
You now have 20 seconds to select one of the sub-menus.
Remote starter transmitter programming procedure
1. Enter programming mode (see above)
⎯ the antenna embedded LED will stay
on
for up to 20 seconds.
2. Before the LED turns off, turn the ignition key to the
IGNITION ON (RUN)
position and immediately to the
OFF
position.
3. Press and hold the remote starter transmitter
LOCK
button and keep it down until the LED flashes 5 times quickly.
4. The transmitter has been stored in memory.
5. Repeat steps 1 to 4 for the second remote starter transmitter.
5. Repeat steps 1 to 4 for the second remote starter transmitter.
6. To exit programming at any time, close the hood.
Note: Each unit can store 4 remotes in its memory.
(REMOTE STARTER)
Programming Assistance Button
(PAB)
FIG 11
AS PRG-1000 (tech tool) remote starter transmitter programming procedure (optional)
* Please refer to the AS PRG-1000 user guide for proper procedure.