DEI Headquarters Inc. HYU1800 Manuel D’Utilisation
Page-3
GOVERNMENT REGULATIONS
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with the Industry Canada Radio Standards Specification RSS 210. Its use is authorized only on a no-
interference, no-protection basis; in other words, this device must not be used if it is determined that it causes harmful
interference, no-protection basis; in other words, this device must not be used if it is determined that it causes harmful
interferences to services authorized by IC. In addition, the user of this device must accept any radio interface that may be
received, even if this interference could affect the operation of the device.
received, even if this interference could affect the operation of the device.
Warning:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate this device.
operate this device.
GENERAL
General service information
Installation points to remember
•
Always make sure to cover fenders, seats, and floor areas before starting to work.
•
When working on a vehicle, always roll down a window to avoid being locked out of the car.
•
Always make all of the necessary connections BEFORE plugging in the module.
•
Never install the control unit where it could interfere with normal operation or obstruct service technicians.
•
Airbag wires are not always labelled (i.e. yellow split loom/tubing) on the harness itself, but will always be
labelled at the connector plugs where they terminate.
labelled at the connector plugs where they terminate.
•
Make sure that all safety equipments – i.e., the hood switch and the warning label -- are installed.