DEI Headquarters Inc. NAH6602 Manuel D’Utilisation

 

 

P. 9 

Keypad lock  
Note: In order for this feature to work, “Secure function” must be set to ON. 
If there is no activity within the programmed time, the keypad will automatically lock 
after 5 seconds, 10 seconds or 20 seconds. 

• 

Press 

 

for about 1sec

, 

to unlock the transmitter’s keypad. 

LCD illumination: 
When this function is enabled, the LCD will illuminate each time Lock, Unlock or 
START is activated. 

 Button Function: 

The order of LEVELS and MENU can be re-arranged using the 

 Button Function 

Menu.  

Function Button 

programming 

M 1 2 3 
1 2 3 M 
2 3 1 M 
2 1 3 M 
3 1 2 M 

 

MENU, level 1, level 2, level 3 

Level 1, level 2, level 3, MENU 
Level 2, level 3, level 1, MENU 
Level 2, level 1, level 3, MENU 
Level 3, level 1, level 2, MENU  

 

If your vehicle has a manual transmission you must read the following indications. The unit must 
first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready 
Mode, it cannot remote start the vehicle.  
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on the 
option that was selected by your installer. Therefore, you must follow the appropriate procedure 
between the two described below in order to set your vehicle into Ready Mode. 
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time. 
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is 
pressed, if the parking brake is disengaged or if the ignition key is turned to the IGNITION ON 
(RUN) position. 

To set the system to Ready Mode: 

1.  Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the 

neutral position. 

2.  With the engine already running, apply the 

parking brake once and release the brake 
pedal. 
 

2.  With the engine already running, apply the 

parking brake twice within 10sec.  
Make sure to release the brake pedal. 
The parking lights will flash 3 times quickly 
and remain lit.  
Skip to step 4. 

3.  Within 20 sec. of engaging the parking 

brake, press and hold 

, 

 or   on 

the transmitter. 
The parking lights will flash 3 times quickly 
and remain lit. 

- 

4.  Remove the key: the engine will continue running.