Lg Electronics LST2300 Manuel D’Utilisation
LGIC CDMA Fixed Wireless Terminal
LST-230(F) / 2300(F)
17
4
4
.
.
S
S
y
y
s
s
t
t
e
e
m
m
F
F
e
e
a
a
t
t
u
u
r
r
e
e
s
s
4.1 Hook flash
When the terminal receives a
hook-flash
from the connected telephone device, it will automatically allow:
1. For producing dial tone again after a phone number has been dialed without connection.
2. The use of special cellular services which may be available in your cellular service area.
Note: Hook-flash is accomplished in a call through either pressing the dedicated
hook-flash
key which is
available on some phones or through a rapid single press of the hang-up mechanism upon which the
handset rests when the phone is hung up.
handset rests when the phone is hung up.
4.2 Dial Delay Time(Enblock mode only)
When placing a call, the phone number is sent over the network after last digit is dialed. In order to insure
adequate time for dialing the last digit, a delay of 5 seconds is programmed into the terminal.
adequate time for dialing the last digit, a delay of 5 seconds is programmed into the terminal.
4.3 ROH (Receiver Off Hook)
If the telephone equipment remains “off-hook”, meaning that the handset is left off of its cradle as it would be
when you hang up, with no dialing activity for about 45 seconds, a ROH tone emits from the receiver for a
period of 60 seconds.(In the overlap dial mode, above “45 seconds” or “60 seconds” may be different according
to the system.)
( This feature may be available or not by country specification.)
when you hang up, with no dialing activity for about 45 seconds, a ROH tone emits from the receiver for a
period of 60 seconds.(In the overlap dial mode, above “45 seconds” or “60 seconds” may be different according
to the system.)
( This feature may be available or not by country specification.)
4.4 Special Cellular Services
Many cellular systems offer special services such as call waiting, call forwarding, etc. You can purchase these
services from your cellular service provider. There are certain dialing sequences to be entered, which vary from
service provider to service provider. The service provider will provide the dialing instructions for your system.
services from your cellular service provider. There are certain dialing sequences to be entered, which vary from
service provider to service provider. The service provider will provide the dialing instructions for your system.
Call Forwarding – An incoming call can be delivered to another telephone number programmed. Please
contact your cellular service provider to use this feature.
contact your cellular service provider to use this feature.
Call Waiting – You can receive another incoming call during a call. In this case, you will hear beep tone and
then you can connect the second call holding the first call by entering a code required by cellular service
provider. Your cellular service provider may require
then you can connect the second call holding the first call by entering a code required by cellular service
provider. Your cellular service provider may require
hook-flash
(a quick, simulated "hang up") to answer the
waiting call. Other providers may require entering the codes involving digits 1-9, *, and # to answer a waiting
call.
call.
Three-way Conference Calls - For three-way conference calls, a hook-flash transmits the SEND command.
Please contact your cellular service provider for more information on using this service.
Please contact your cellular service provider for more information on using this service.
F Example
1 Dial the first number and wait until connected;
2 When connected, give
hook-flash
and dial the second number and give one more
hook-flash
to be connected;