Memtec Corporation 950-12LR-HHC Manuel D’Utilisation
Model 950-12LR-HCC
Operation Manual
Page 11
o
Adjust the year using <up> and <down> then press <enter>
• To review the leads and verify electrode connectivity navigate to Review
Leads then press <enter>
o
View each lead to verify a good signal and press <right> to
advance to the next lead
o
After all leads have been verified press <enter>
• To Start Transmitting the ECG signal navigate to Start Transmitting, verify
the Patient ID and press <enter>
Upon pressing <enter> on the start transmitting item the unit will begin the data
transmitting operation.
Recording Termination
Normal Termination
Disconnect the patient electrode leads
When the recording has completed, simply disconnect the patient electrode
leads. The recorder is now free from the patient and the data stored in the PC
can be retrieved and analyzed.
leads. The recorder is now free from the patient and the data stored in the PC
can be retrieved and analyzed.
Retrieving Recording Data
Recorder Maintenance
Use a mild detergent and water on a soft cloth to clean the recorder and pouch.
Remove any adhesives from the patient lead wires with an adhesive tape
remover solution or swab. Use a mild disinfectant.
DO NOT use alcohol or acetone on the lead wires since they could stiffen and
crack the insulating plastic.
DO NOT leave a battery in the recorder while not in use. Damage from battery
leakage and corrosion could result.
Remove any adhesives from the patient lead wires with an adhesive tape
remover solution or swab. Use a mild disinfectant.
DO NOT use alcohol or acetone on the lead wires since they could stiffen and
crack the insulating plastic.
DO NOT leave a battery in the recorder while not in use. Damage from battery
leakage and corrosion could result.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
following two conditions: