TransCore 0596465PT15 Manuel D’Utilisation

Page de 276
Choosing, Installing, and Removing Tags
3-15
Figure 3-15  Upper Placement Over the Top Area of the License Plate
Installing eGo Windshield Sticker Tags
eGo WSTs are designed to be attached by a semi-permanent adhesive to the interior 
surface of nonmetallic windshields 0.190 to 0.230 inches (4.82 to 5.84 mm) in thick-
ness. For optimum performance, you must install the tag at least 2 inches (5 cm) from 
the metal in the windshield frame and 0.75 inch (1.9 cm) from the rearview mirror 
support post. Detailed instructions are found in the pocket guide “Quick and Easy 
Installation Instructions for Windshield Sticker Tag.”
Some vehicles have a tinted area across the top of the windshield. If the tint is conduc-
tive, it can interfere with reading the tag. If a windshield has this conductive tint, the 
tag must be installed at least 2 inches (5 cm) below this tinted area.
Some vehicle windshields contain a metallic treatment that could prevent an interior 
windshield-mounted tag from being read. However, many of these metallized wind-
shields have areas that are not metallized. On a vehicle without open areas in its met-
allized windshield, you might need to install an Encompass 4H Reader-compatible 
LPT on the vehicle. See the section 
 and the section 
. Contact 
TransCore for more information. See the section