TransCore 2611SS Manuel D’Utilisation
Tuning the Lane
5-17
Figure 5-7 Location of LEDs on Reader Logic Card
If the lane performs to the stated standards, tuning is complete. If not, perform trouble-
shooting procedures listed in Chapter Chapter 6, “Troubleshooting the Installation” of
the IT2200 Reader System Installation & Maintenance/Service Guide.
shooting procedures listed in Chapter Chapter 6, “Troubleshooting the Installation” of
the IT2200 Reader System Installation & Maintenance/Service Guide.
ATA Tag Dynamic Performance Drive-Through Tag
Test
Test
1.
Replace the IT2221 Tag with an ATA-type Tag.
Note: Remove the IT2221 Tag from the vehicle or place it in a sealed protective
electrostatic device bag.
electrostatic device bag.
2.
From the Reader menu, select Download CAM File. Select the
HDSKS_ATA.cam file. When the HDSKS_ATA.cam file has been successfully
downloaded, an information box appears indicating that the CAM file is loaded
into the reader logic card. Click OK to exit this screen.
HDSKS_ATA.cam file. When the HDSKS_ATA.cam file has been successfully
downloaded, an information box appears indicating that the CAM file is loaded
into the reader logic card. Click OK to exit this screen.
3.
From the Reader menu, select CAM Sequencing. When the CAM
Sequencing screen appears, select Non-Virtual Sequence. This command
initiates the host-reader interaction for this type of CAM file.
Sequencing screen appears, select Non-Virtual Sequence. This command
initiates the host-reader interaction for this type of CAM file.
4.
From the Reader menu, select Tag Command Mode. When the Tag
Command Mode screen appears, select Process Autonomous Commands.
When the Process Autonomous Commands screen appears, select Disable
Response Display, then click Run.
Command Mode screen appears, select Process Autonomous Commands.
When the Process Autonomous Commands screen appears, select Disable
Response Display, then click Run.
5.
Toggle Run/Pause on the host computer to clear the counter.