KYE Systems Corp GMZI4 Manuel D’Utilisation
ENGLISH
1
Hardware Installation
1. Install two AA batteries each into the mouse and keyboard.
2. Plug in your USB receiver to a USB port of your PC.
2. Plug in your USB receiver to a USB port of your PC.
Software Installation
1. Place your CD driver in your PC drive for software installation.
2. Follow the instructions on the screen to finish the software
2. Follow the instructions on the screen to finish the software
installation.
Replace Batteries
If the mouse or keyboard does not work properly, then the batteries
have lost their charge, so you need to replace them.
Warning: do not mix or use different types of batteries at the same time.
have lost their charge, so you need to replace them.
Warning: do not mix or use different types of batteries at the same time.
ID Channel Setting
The channel ID is factory preset. The green LED (data transmission
indicator) will be lit constantly when the wireless device is in normal
operation. In case your wireless devices do not work, reset the ID
channel by:
1. Press the connect button on the receiver and the LED will be blinking
indicator) will be lit constantly when the wireless device is in normal
operation. In case your wireless devices do not work, reset the ID
channel by:
1. Press the connect button on the receiver and the LED will be blinking
for connection.
2. Press the connect button on each wireless device within 20 seconds
and observe if the LED light on the receiver has gone off. If yes, it
means the wireless device is ready for use.
means the wireless device is ready for use.