KYE Systems Corp KM002 Manuel D’Utilisation
3
▼
Establishing a communications link
The mouse has 256 identification codes that allow the mouse and its receiver to operate
without interference from other radio frequency devices.
without interference from other radio frequency devices.
After your computer detects the USB receiver and the driver is installed, you must establish
a communications link between the mouse and its receiver BEFORE you can use the
mouse. To do this, follow the instructions below:
a communications link between the mouse and its receiver BEFORE you can use the
mouse. To do this, follow the instructions below:
. Press and release the link button located on the receiver.The receiver’s status light
blinks when the receiver is activated.
blinks when the receiver is activated.
2. Press and release the link button, located on the bottom of the mouse, and you are now
ready to use the mouse.
ready to use the mouse.
▼
Mouse Power Management
a. Push back the lock of dongle holder.
b. Pull the dongle holder till the end to power off
c. Insert receiver to the dongle holder while travelling.
b. Pull the dongle holder till the end to power off
c. Insert receiver to the dongle holder while travelling.
d. The mouse will go into “sleep mode” after 5 minutes of idling status.
To awake the mouse, just move or click any key of the mouse.
e. While power is running out, the LED light will turn to RED with blinking light.
To awake the mouse, just move or click any key of the mouse.
e. While power is running out, the LED light will turn to RED with blinking light.
English
Link Button
a
b
c
Link Button