Suncon Toys Industry Ltd 604384 Manuel D’Utilisation
Chevrolet Avalanche
transmitter
user’s guide
Thank you for purchasing your RadioShack
Petersen’s 4-Wheel & Off-Road Chevrolet Avalanche.
Scaled to 1:13 the size of a real Chevy Avalanche, it
can reach speeds of up to 600 feet per minute and
climb 40 degree inclines. This truck is perfect for
children ages 8 and up.
Petersen’s 4-Wheel & Off-Road Chevrolet Avalanche.
Scaled to 1:13 the size of a real Chevy Avalanche, it
can reach speeds of up to 600 feet per minute and
climb 40 degree inclines. This truck is perfect for
children ages 8 and up.
1. Extend the transmitter’s antenna to its full
length.
2. Turn the transmitter and the truck on. The
headlights should turn on.
3. Pull the speed control trigger toward the
handle to move forward. Pull all the way in for
turbo speed.
turbo speed.
4. Push the trigger away from the handle to move
backward.
5. Release to stop.
6. Use the steering control wheel to turn left and
6. Use the steering control wheel to turn left and
right.
7. Release the wheel to drive straight.
8. When you fi nish driving the vehicle, turn it off.
8. When you fi nish driving the vehicle, turn it off.
You can use the gear switch on the
transmitter to select high or low gear.
Raise it up for high gear to drive on
rough surfaces, the indicator lights
red. Put it down for low gear to drive
on rough surfaces, the indicator light
green.
transmitter to select high or low gear.
Raise it up for high gear to drive on
rough surfaces, the indicator lights
red. Put it down for low gear to drive
on rough surfaces, the indicator light
green.
Please read this user’s guide before
installing, setting up and using your new product
www.radioshack.com
60-4384
Petersen’s 4-wheel &
off-road Chevrolet Avalanche
To power your truck, you will need one 9V battery
for the transmitter and one 9.6V battery pack for
the truck. Neither of these batteries is included,
but both are available at your local RadioShack or
online at www.radioshack.com.
for the transmitter and one 9.6V battery pack for
the truck. Neither of these batteries is included,
but both are available at your local RadioShack or
online at www.radioshack.com.
in the transmitter
1. Remove the cover.
2. Put the 9 volt battery in the compartment as
2. Put the 9 volt battery in the compartment as
indicated by the polarity symbols (+ and -).
Replace the cover.
Replace the cover.
When the transmitter’s range
decreases, replace its battery.
decreases, replace its battery.
NOTE
in the truck
1. Remove the battery compartment cover.
Replace when fi nished.
2. Attach the battery pack’s connector to the
truck’s connector. It fi ts only one way.
3. Place the battery pack in its compartment.
Replace the cover and secure it.
When the truck’s operation becomes
erratic, replace the batteries.
erratic, replace the batteries.
NOTE
NOTE
wheel alignment
If the car does not drive in a straight line when you
release the right control lever, adjust the wheel
alignment control on the bottom of the car. Turn
the control toward L if the car is pulling to the right
or toward R if the car is pulling to the left.
release the right control lever, adjust the wheel
alignment control on the bottom of the car. Turn
the control toward L if the car is pulling to the right
or toward R if the car is pulling to the left.
Battery
compartment
cover
Battery
connector
9V Battery
9.6V
Battery Pack
Alignment
control
ON/OFF
switch
Antenna
Steering
control wheel
Speed
control trigger
Front
Wheels
Gear
Switch