Advance Security Inc T42 Manuel D’Utilisation

7

 The PROPLM Security System has the ability to operate from up to 4 remote controls. Follow these steps to
add a remote control to your system.

1. Make sure the system is disarmed and the ignition is off.

2. Turn the ignition on.

3. Press and hold the override button. After 10 seconds the system will chirp 3 times indicating the
system has entered programming mode.

4. Release the button.

5. Press the LOCK button on the remote to be programmed. The horn will sound once, indicating that
the system has learned the remote.

6. Repeat step 5 for any addition remote controls.

7. Turn the ignition off to exit the programming mode.

 If one of your remote controls is lost or stolen, follow these steps to remove it from your system:

1. Have all of the remaining remotes available

2. Enter the remote control programming mode by following steps 1-4 from Adding Remote Controls
to Your System shown above.

3a. If you only have 1 remaining remote, press the LOCK button 4 times, pausing for one second

between each press. The horn must honk each time you press the button.

3b. If you have 2 remaining remotes, press the LOCK button on each remote 2 times, pausing for
one second between each press. The horn must honk each time you press the button.

3c. If you have 3 remaining remotes, press the LOCK button on the first remote 2 times and 1 time
on the following 2 remotes, pausing for one second between each press. The horn must honk each
time you press the button.

4. Turn the ignition off to exit the programming mode. The lost or stolen remote will no longer operate
the system.

Remote does not work:

Weak or dead battery.

Change battery.

Remote not programmed.

Program remote.

System will not arm:

Door or entrance is open.

Close  entrance.

Courtesy light is on.

Turn courtesy light off.

System is in Valet mode.

Exit Valet mode.