HeathCo LLC 64WDB45TX Manuel D’Utilisation
-2-
598-1105-07
Pull tab to
activate batteries
Figure 1
WARNING: To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
• If battery is swallowed, immediately notify doctor.
1. Remove back of push button. To remove back
of push button, push in tab on bottom with a small
screwdriver (see Figure 1). Pull battery tab to acti-
vate factory installed batteries. Note: See Trouble-
shooting for replacement battery information.
screwdriver (see Figure 1). Pull battery tab to acti-
vate factory installed batteries. Note: See Trouble-
shooting for replacement battery information.
2. Test range. Temporarily position push button
where you want it mounted. Press push button
to verify chime and push button work properly. If
chime does not sound, see Troubleshooting.
to verify chime and push button work properly. If
chime does not sound, see Troubleshooting.
3. Mount push button. Use either screws or double
sided tape to mount push button.
•
Screw Mounting: To mount with screws, re-
move back of case by pushing in tab on bottom
with a small screwdriver (see Figure 1). Note:
Remove material in screw holes (if needed)
before mounting with screws. Attach back of
case to door jamb or wall (see Figure 2). Snap
front of push button on.
move back of case by pushing in tab on bottom
with a small screwdriver (see Figure 1). Note:
Remove material in screw holes (if needed)
before mounting with screws. Attach back of
case to door jamb or wall (see Figure 2). Snap
front of push button on.
•
Tape Mounting: When attaching push button
using double sided tape, make sure the surface
of the door jamb or wall is clean.
using double sided tape, make sure the surface
of the door jamb or wall is clean.
Figure 2