Tyco Safety Products/Sensormatic AMB44 Manuel D’Utilisation
PRELIMINARY
ZBAMB2070 MOBILE HANDHELD DEACTIVATOR
8200-0958-05, REV. 1B
INSTALLATION AND USER GUIDE
2 of 5
Using the Device
1. Remove the scanner/deactivator
from the Motorola Base Charging
Station.
Station.
2. Aim the scanner at the barcode and:
a) Pull the trigger. The scanner will
beep indicating a successful
scan.
scan.
b) Release the trigger; the LEDs on
the deactivator will flash yellow
for 3 seconds. Within this
window, perform step 3.
(If you were unable to perform
step 3 within this window, repeat
step 2.)
for 3 seconds. Within this
window, perform step 3.
(If you were unable to perform
step 3 within this window, repeat
step 2.)
3. Swirl the deactivator coil in 2.54cm
(1in) circles no more than 11.4cm
(4.5in) from the barcode. Observe
deactivation indications.
(4.5in) from the barcode. Observe
deactivation indications.
Deactivation Indications
LEDs / Audio
Indicates
Green flash +
1 beep
1 beep
Deactivation successful
Red flash +
3 beeps
3 beeps
Deactivation failed
4. When finished, seat the
scanner/deactivator firmly into the
Motorola Base Charging Station to
maintain the battery charge.
Motorola Base Charging Station to
maintain the battery charge.
Fault Indications
LEDs / Audio
Indicates
Flashing red
and yellow
and yellow
Replace the battery.
Red flash +
beep every
500ms until 30
seconds has
elapsed
beep every
500ms until 30
seconds has
elapsed
Deactivator is out of
range of the Sync AP
device.
range of the Sync AP
device.
Solid red
Replace the
deactivator.
deactivator.
IIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIII