Tyco Safety Products/Sensormatic AMB9020 Manuel D’Utilisation

Preliminary 2003-11-21 

DUAL ANTENNA SCANMAX PRO DEACTIVATOR CONTROLLER 

8200-0365-01, REV. 1A 

INSTALLATION AND SERVICE GUIDE 

1 of 12

 

 

 

The Dual Antenna Deactivator controller, along 
with an antenna, is used to deactivate security 
labels. Antennas used with the controller are: 
•  PowerPad Pro (ZBSMPPP) 
•  Slim Pad Pro (ZBSMPSP) 
•  CompactPad Pro Tabletop (ZBSMPCP) 
•  CompactPad Pro Flush Mount (ZBSMPCP-F) 
•  HS Pro (ZBSMPHS) 
•  LP Pro (ZBSMPLP) 
•  IP Pro (ZBSMPIP) 
•  IS Pro (ZBSMPIS) 
•  NS Pro (ZBSMPNS) 
•  NS2 Pro (ZBSMPNS2) 

 If only one antenna 

is used, it MUST be plugged into the Antenna 1 
port or the unit will not function properly. 

 If two antennas are 

used and one is an IS Pro antenna and one is not, 
the IS Pro antenna MUST be plugged into the 
Antenna 1 port or the unit will not function properly. 

 

 
© Sensormatic 2003 

 

This guide explains how to install, setup, and 
service the Dual Antenna Deactivator controller. 
Other related documents are: 
•  Planning Guide, 8200-0365-03 
•  Software Configurator Guide, 8200-0365-04 

Note: Because customer requirements dictate the 
placement of components, your Sensormatic 
representative will supply this information 
separately. 

Call 1-800-543-9740 
(Sensormatic / ADT Customer Response Center)