Tyco Safety Products/Sensormatic AMSUSUPB Manuel D’Utilisation
ULTRA 1.5 METER ABS PEDESTAL SYSTEM
8200-1048-06, REV. A
INSTALLATION GUIDE
14 of 44
*8200-1048-06*
• If you are trenching the floor between the pedestals, ensure the proposed trench extends under the
pedestal location so cables can enter the pedestal from its base underneath. Then, using a floor saw,
trench the floor from pedestal to pedestal. The depth of the trench is 1 centimeter, or 3/8 inches. The
width of the trench is 1 centimeter, or 3/8 inches.
trench the floor from pedestal to pedestal. The depth of the trench is 1 centimeter, or 3/8 inches. The
width of the trench is 1 centimeter, or 3/8 inches.
Important: Direct burial without conduit is not permitted in European Union (EU) countries.
2. Note: Skip this step, if you are installing only a single primary pedestal.
Run the interconnect cable between the primary and secondary pedestal and up through the base. The
interconnect cable can enter the base either through the strain-relief on the bottom of the base or from the
center of the side.
interconnect cable can enter the base either through the strain-relief on the bottom of the base or from the
center of the side.
3. Route the AC cable to the primary pedestal through the conduit access hole in the base.
WARNING:
Do not run the power and interconnect cable in the same conduit or raceway. Building
codes require that power wiring be separated from other types of wiring.
4. If you are installing an optional device, for example, a digital remote alarm or auxiliary receivers, run the
device cable or cables up through the base of the primary pedestal, and along the side of the pedestal
using the cabling guide on the pedestal chassis.
using the cabling guide on the pedestal chassis.
Important: The Ultra 1.5 meter ABS Pedestal System does not provide power for the AMC-1060 Digital
Remote Alarm. Because the system does not provide power, you need a nearby power outlet to support the
required AC adapter. Confirm the location of the power outlet before you run the wires.
Remote Alarm. Because the system does not provide power, you need a nearby power outlet to support the
required AC adapter. Confirm the location of the power outlet before you run the wires.
Important: The maximum cable distance from the primary pedestal to each remote alarm is about
12.2 meters, or 40 feet.
12.2 meters, or 40 feet.
If you are connecting a digital remote alarm to the system, the wire you use to connect the digital
remote alarm to the pedestal must be shielded, and you must connect the shield wire at both ends.
remote alarm to the pedestal must be shielded, and you must connect the shield wire at both ends.
Step 4: Securing the pedestal to the floor
To secure the Ultra 1.5 meter pedestal to a floor, complete the following steps:
1. Level the pedestal base, or bases.
2. Locate the anchor wedges, 2880-0105-01, from the Pedestal Mounting Installation Kit, 0352-0781-01. Insert
the anchor wedges into the holes in the floor, and tap the anchors into the holes.
3. Place the pedestal over the four protruding anchors in the floor.
4. Secure each pedestal base to the floor using the four screws, 5801-4174-520, and the four anchors, 2880-
0105-01, from the Pedestal mounting installation kit, 0352-0781-01.
5. Locate the pedestal that you previously set side, and slip the pedestal over the pedestal base.