Tyco Safety Products/Sensormatic AMSUSUPB Manuel D’Utilisation
ULTRA 1.5 METER ABS PEDESTAL SYSTEM
8200-1048-06, REV. A
INSTALLATION GUIDE
30 of 44
*8200-1048-06*
Field replaceable units
A complete parts list is available online at
. Login, and on the Tech
Support page, select Part Information.
Part number
Description
0500-9887-01
Lens cover
0312-3112-05
AMS-1146 Main Board
0312-1617-01
Alarm board APS 1002
0312-7266-01
AMS-1146 Secondary Board
0404-0566-01
Covers
Boot Loader Mode
If the firmware in the main controller board is corrupt, you can override the normal boot sequence to prevent
the controller board from using the firmware. Instead, the controller board will stop during the boot process and
wait for new firmware to be downloaded.
the controller board from using the firmware. Instead, the controller board will stop during the boot process and
wait for new firmware to be downloaded.
Important: Only use the boot loader procedure if you can not successfully download firmware to
the controller board.
the controller board.
To update the firmware on the main controller board, complete the following procedure:
WARNING:
Risk of electric shock
High-voltage AC is present on the Cap board whenever the controller is on.
Ensure the pedestal is powered off before installing the jumper on the capacitor board.
Ensure the pedestal is powered off before installing the jumper on the capacitor board.
1. Turn off power to the pedestal.
2. On the main controller board, jumper pins 1 and 2 on P18. For the location of P18, see Appendix F: Main
board pinouts on page 44.
3. Connect the service laptop to the system and launch the CE ADS4 Platform Configurator.
4. Apply power to the system. The following message displays:
Boot utility is running. A Flash Download is needed. Please select a file to
download.
download.
5. Click OK.
6. On the Setup page, select Flash Download. See Figure 19.
7. Click Browse… and select the flash application firmware version 1.0014 for the controller board.
CAUTION: Do not interrupt the flash process.
8. Click the Start Flash Download button. For the location of the button, see Figure 19.
9. Once the download is complete, remove the jumper on P18, and reboot the system by clicking the Reset
Pack button. See Figure 19.