Tyco Safety Products/Sensormatic AMSUSUPB Manuel D’Utilisation
ULTRA 1.5 METER ABS PEDESTAL SYSTEM
8200-1048-06, REV. A
INSTALLATION GUIDE
7 of 44
*8200-1048-06*
CAUTION: The AC source must be a two-wire plus ground, 24-hour, unswitched outlet with less than
0.5Vac between neutral and ground.
0.5Vac between neutral and ground.
CAUTION: For permanently connected equipment, a 15A or 20A, two-pole, ganged disconnect device,
which also provides short circuit and overload protection, and has a minimum 3 millimeter open circuit
clearance, in accordance with the National Electric Code and applicable local codes must be installed
by a licensed electrician at a location readily accessible to the equipment.
which also provides short circuit and overload protection, and has a minimum 3 millimeter open circuit
clearance, in accordance with the National Electric Code and applicable local codes must be installed
by a licensed electrician at a location readily accessible to the equipment.
CAUTION: For pluggable equipment, the socket-outlet shall be installed near the
equipment and shall
be easily accessible.
Important:
• Do not share the AC source with neon signs, motors, computers, cash registers, terminals, or data
communications equipment.
• Do not use orange-colored outlets dedicated for computer equipment.
CAUTION: For continued protection against risk of fire, replace fuse only with same type and rating.
Implanted medical devices
This anti-theft system complies with all applicable safety standards. However, people with implanted electronic
medical devices can ask if the store has an anti-theft system, and its location. Although most anti-theft systems
are easily seen, some can be concealed. To help individuals with implanted medical devices, consider the
following health and safety guidelines:
medical devices can ask if the store has an anti-theft system, and its location. Although most anti-theft systems
are easily seen, some can be concealed. To help individuals with implanted medical devices, consider the
following health and safety guidelines:
Health and safety
Place the anti-theft system antennas to ensure customers behave in the following ways:
• Do not linger near, or lean on them while making their purchase.
• Are only near the front of them while exiting the checkout area.
• Are only near the front of them while exiting the checkout area.
For exit systems, place anti-theft system antennas:
• Close to exit and entrance doors, encouraging the customer to pass through them. Do not use antennas
intended for exits in an aisle configuration.
• Away from fixtures, equipment, amusements, and other signage that can attract customers to them.
Apply ‘Anti-theft’ signage
• ‘Anti-theft’ labels are placed on each antenna, including those hidden behind door frames and other
structures. Do not cover these labels with other signage.
• In non-English speaking countries, apply ‘Anti-theft’ labels in the local language to the antennas. For hidden
antennas, apply an ‘Anti-theft’ label in the local language to each side of the door frame facing the doorway
about 1.2 meters or 4 feet above the floor. You can order local language labels, 2412-0170-XX, from your
distribution center.
about 1.2 meters or 4 feet above the floor. You can order local language labels, 2412-0170-XX, from your
distribution center.
• To improve customer awareness of the anti-theft system, encourage the store to display signs that state it
has an anti-theft system. You can order awareness materials through your sales representative.