Tyco Safety Products/Sensormatic UMEXCAL Manuel D’Utilisation
AMS-1070 EMI SHIELD INSTALLATION GUIDE (8200-0127-12, REV. A)
1 of 1
AMS-1070 Controller
EMI Shield
EMI Shield
Installation Guide
Two EMI shields are required. To install each
shield:
shield:
1. Run the unterminated cable through the slot in
the shield from the direction shown, and then
connect the cable ends to the cable connector
according to wiring diagrams in AMS-1070
Controller Install Guide 8200-0127-06.
connect the cable ends to the cable connector
according to wiring diagrams in AMS-1070
Controller Install Guide 8200-0127-06.
2. Attach the shield to the controller using the four
screws supplied.
© Sensormatic 2002
EMI Shield