Include U Technologies Inc. R433-6B1W Manuel D’Utilisation

Page de 2
 
 
 
CONGRATULATIONS ON YOUR PURCHASE OF THE iNAV-BOSS 
WIRELESS RF REMOTE CONTROL AND RECEIVER DOCK
 
 
The Boss Remote with iNav Bottom Dock was designed to provide maximum control of your iPod/iPhones 
from anywhere you choose to place it regardless of whether it is in your backpack or over a hundred  feet 
away in a different room connected to your home stereo. Its small size allows audio connection on newer 
iPod version. 
iNav-Boss Operation 
 
iPod RF receiver setup: (FIG 1) 
Plug the iNav dock into the 30 pin dock connector located 
on bottom of your iPod/iTouch/iPhone.  Please WAIT 15 
seconds for the automatic self-diagnostic  to run.  Plug in 
your ear  buds or  speakers or connect to your home stereo 
through a set of RCA jacks (supplied in the  iNav-Boss 
kits).  With iPhone/iTouch plug in headset after inserting 
the iNav dock  and waiting 5 seconds.  To sync or charge 
the iPod, simply plug your USB/Firewire or charging 
device into the bottom of the iNAV while it’s connected to 
the iPod/iTouch/iPhone. 
 
Advanced Low Power Mode (ALPM): 
The iNav uses an advanced power down mode, which minimizes current draw on your iPod/iPhone 
battery if you are not connected to a constant power source.  After 2 hours of sensing no remote 
commands being sent, the iNav goes into a battery saving mode.  The iNAV receiver will automatically 
repower itself when it detects music playing or a remote button being pressed for more than 0.6 seconds. 
 
Boss Remote Control Functions 
 
 
 
 
 
 
 
iPod/iTouch/iPhone is a registered trademark of Apple Computer, Inc.  All rights reserved.
 
 
Contact us via email
 
    iNav-Boss (Navigator/Boss Manual Revision 1.0) Product Made In Taiwan 
 
 
Features 
                
                > Pass-through 30-pin connector allows charge/sync. 
                > Thin profile (only 0.515”). 
                > Up to 150 ft range. 
                > Supports iPod with 30  pin dock connector from 3
rd
 Gen forward. 
                > Replaceable Battery CR 2025. 
 
Optional iNAV Accessories 
 
Additional iNAV Remotes (Boss / Elite / Standard) 
Pair up to 7 remotes with any iNav receiver dock.  Place a remote in each bedroom, out by pool or anywhere 
you choose to control your music.     
 
Pairing Instructions 
Step 1 – Make sure your iPod/iTouch/iPhone is sufficiently charged. 
Step 2 – Detach iNav receiver from your iPod/iTouch/iPhone and wait 5 seconds. 
Step 3 – Reattach the iNAV receiver to the iPod/iTouch/iPhone dock connector.           
Step 4 – Within 30 seconds of Step 3, press and hold all four buttons simultaneously on the new remote for     
               three seconds (Volume Up, Volume Down -, FF, RW) and release after 5 seconds.  
Step 5 – Wait approximately 5 seconds. The new remote has been paired with the iNav dock. 
 
NAVigation Mode  
 
In Navigation Mode – To enter the NAVigation mode press the center button with the rectangle symbol. Now 
use the Volume up for moving up on an iPod menu, the volume down for moving down on an iPod menu. Use 
the pause to selecting an iPod menu item. Use the Rewind song to go back in the menu. The mode switch must 
be in the left position for NAVigation. The mode switch is the right position for Shuffle On/Off. Once the 
purpose of the switch is set and the case close it will be only usable for the purpose. 
        
 
 
Technical Specifications 
 
Operating Range:
 Up to 150 ft. 
Transmission Method: Radio frequency 
Operating Frequency: 
433.92 MHz 
Remote Power:
 (2) CR2025 3V 
Receiver Power:
 Powered from iPod with Advanced Low Power Mode (ALPM) 
Remote Dimensions/Weight: 2.275” x 1.65” x 0.515” / 0.8 oz 
Receiver Dimensions/Weight: 4.3”  x 0.79” (w/o connector height)  x 0.55” / 0.5 oz 
 
Message Handling  
 
If no audio on headset                 
 
1.) Power on the iTouch or iPhone. 
2.) Plug the iNav dock into the iTouch or iPhone and wait 4 seconds. 
3.) Then plug in the head set connection into the 3.5mm jack. Audio has been rerouted. 
 
 
UU
Rewind/Fast Rewind:
UU
  
Press and release this button to 
move track BACKWARDS. Press 
and HOLD this button to rewind 
through the track 
UU
Volume Down:
UU
  
Press and HOLD this button to 
turn down volume. 
UU
Forward/Fast Forward:
UU
  
Press and release this button to 
move track FORWARD. Press 
and HOLD this button to 
forward through the track. 
 
UU
Volume Up:
UU
  
Press and HOLD this button to 
turn down volume.
 
UU
Play/Pause/Sleep:
UU
  
Press and release to toggle 
between Pause and Play.  Press 
and HOLD for 2 full seconds 
to put the iPod into sleep mode 
 
UU
Enter/Exit Nav Mode:
UU
  
Press this button once to place the 
remote in the Navigation mode. 
Nav the menus in the iPod when 
done press again to return to 
standard operational mode. 
UU
Transmission Red LED:
UU
  
Red LED on when transmitting
 
If either of these two 
message come up on the 
iPod/iToucd/iPhone 
display answer No. Then 
the MP3 unit will now 
response to remote 
commands  
UU
Coin Slot Opens Case:
UU
  
Location of slot for battery change 
or mode button change