HM Electronics Inc XCVR2G4A Manuel D’Utilisation
User Guide | FreeSpeak II™
Page 123
•
Help - Opens the online help for the Configuration Editor
•
Clear Map - Clears the current file from the Configuration Editor buffer. All
the parameters set in the editor will be reset to the startup defaults.
the parameters set in the editor will be reset to the startup defaults.
•
Send File - Sends a firmware file (normally a 4kr file) to the Base station.
This is normally only used to update the Base station firmware, and to
send antenna and beltpack software.
This is normally only used to update the Base station firmware, and to
send antenna and beltpack software.
•
Exit - Exits the Configuration Editor. If a file has been changed or
retrieved from the Base station and not saved, you are prompted to save
the file before exiting the editor.
retrieved from the Base station and not saved, you are prompted to save
the file before exiting the editor.
10.3
Registering beltpacks using the over the air (OTA)
facility
facility
Beltpacks can be registered wirelessly from the Configuration Editor.
1)
Go to the System tab in the editor. Click Start Over the Air
Registration.
Registration.
2)
If the Base station is unavailable for any reason there will be an error
message, otherwise you will see Over the Air Registration Mode
Active.
message, otherwise you will see Over the Air Registration Mode
Active.