HM Electronics Inc XCVR2G4A Manuel D’Utilisation
User Guide | FreeSpeak II™
Page 129
10.4.4.2
Recalling the factory defaults
•
Click Recall Factory Defaults to read back and display the factory
default settings. You can use this option to reset beltpacks to the factory
settings if the saved default settings have been lost or are not suitable.
default settings. You can use this option to reset beltpacks to the factory
settings if the saved default settings have been lost or are not suitable.
10.4.4.3
Saving default settings
•
Click Remember My Default Settings to save the currently displayed
default settings (of the Configuration Editor) for later recall. This allows
you to ensure that all beltpacks are set up to the same default settings if
required.
default settings (of the Configuration Editor) for later recall. This allows
you to ensure that all beltpacks are set up to the same default settings if
required.
10.4.4.4
Closing the Properties window
•
Click CLOSE WINDOW to return to the Configuration Editor main screen.
10.4.5
Beltpack audio levels
The following sections describe how to configure the beltpack audio levels.
Headset Limiter
Use this option to assign a limit to the headset audio.
•
From the Headset Limiter list, select a headset limiter setting. The
settings run from -12dB to +8dB in steps of 1dB. The default is 0dB.
settings run from -12dB to +8dB in steps of 1dB. The default is 0dB.
Note:
The lowest level may vary depending on model type and software version.
Sidetone
Level
Use this option to assign a microphone sidetone level.
•
From the Sidetone Level list, select a sidetone level setting. The settings
run from -70dB to 0dB. The factory default is -9.6dB.
run from -70dB to 0dB. The factory default is -9.6dB.
Master Volume
Use this option to assign a master volume level.
•
From the Master Volume list, select a master volume setting. The
settings run from -70dB to 0dB. The factory default is -9.6dB.
settings run from -70dB to 0dB. The factory default is -9.6dB.
Line In Vol Level
Use this option to set the level of the line in (program) feed.
•
From the External Line In Gain list, select a setting. The settings run
from -15dB to 6dB. The factory default is 6dB.
from -15dB to 6dB. The factory default is 6dB.
Port input gain
Use this option to set the level of gain on the input from the Base station