HM Electronics Inc XCVR2G4A Manuel D’Utilisation
User Guide | FreeSpeak II™
Page 25
3)
The beltpack registration details must be added to the software
configuration.
configuration.
3.4.1
Over the air (OTA) registration of a beltpack from the
Base station
Base station
Beltpack registration mode can be registered OTA from the Base station.
Note:
You can also use a previously registered beltpack to enable registration mode.
See 8.8.1 Enabling OTA registration mode.
See 8.8.1 Enabling OTA registration mode.
1)
From the Base station menu go to MAIN MENU ->SYSTEM->REG->START
using the setup/enter rotary encoder on the front panel of the Base
station.
using the setup/enter rotary encoder on the front panel of the Base
station.
Figure 3-6 OTA registration from the Base station
This enables registration mode. Enable registration mode has a two
minute inactive time-out. This is so that several beltpacks can be
registered sequentially without the user having to re-enable registration
mode. It also prevents unauthorized users from registering beltpacks.
minute inactive time-out. This is so that several beltpacks can be
registered sequentially without the user having to re-enable registration
mode. It also prevents unauthorized users from registering beltpacks.
2)
On the beltpack to be registered, hold the menu key for two seconds to
enter MENU options. Scroll to SYSTEM CONNECT using the rotary
controllers and select it using key D. In menu mode the D key on the
beltpack operates as SELECT and the C key exits the menu level and
cancels the selection.
enter MENU options. Scroll to SYSTEM CONNECT using the rotary
controllers and select it using key D. In menu mode the D key on the
beltpack operates as SELECT and the C key exits the menu level and
cancels the selection.
Note:
On a new system there will be no previous connections at this
point. However, if the beltpack is currently connected to an active
system, a confirmation screen will appear. Select Yes to connect
to a new system or No to remain connected to the current system.
point. However, if the beltpack is currently connected to an active
system, a confirmation screen will appear. Select Yes to connect
to a new system or No to remain connected to the current system.